|
[Sponsors] |
December 9, 2010, 06:05 |
Iso Surface for a region
|
#1 |
New Member
Join Date: Jun 2010
Posts: 27
Rep Power: 15 |
Hello. I am simulating a wind tunnel test, and I want to plot some iso surfaces for the low speeds corresponding to the vortex regions.
The problem is that if i create the region Fluent will include also the walls, and I don't want it. How can I tell Fluent to create the surface only in a smaller volume? Please let me know asap if you know it or if the question is not clear. Thanks, Fabio |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |