|February 7, 2011, 14:27||
Question) fan simulation & B.C
Kim sang heuon
Join Date: Feb 2011
Posts: 5Rep Power: 6
I want to compare experimental data in anechoic room
with fluent simulation result.
So, in ICEM-CFD , i meshed huge room(hexaheron room) and fan.
(fan diameter = 70mm , room size = 2400mm x 2400mm x 1500mm)
To get initial state information for sliding mesh model,
i used steady solver and MRF model.
I used wall B.Cs at floor and pressure inlet & pressure outlet B.Cs at other sides.
Then, ' reversed flow ' is occurred and it didn't vanished .
How can i vanish this message.
Just extend my room size?
In my case,
can I change pressure inlet & pressure outlet B.Cs to pressure far-field B.Cs?
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fan Blade Simulation. 2D CFD with FLUENT? CFX?||aerospain||ANSYS||0||December 3, 2010 07:08|
|Axial Fan Simulation - physics laws not held true||Giovan||CFX||16||May 14, 2010 23:21|
|who know about fan simulation||mohr76||FLUENT||1||September 30, 2004 11:38|
|Fan simulation in underhood||Mair||CD-adapco||0||January 8, 2004 11:14|
|Question concerning about the flow simulation of a fan in an engine room.||ghlee||Main CFD Forum||3||October 21, 1998 07:05|