boundary conditions

vishal_kumar · February 9, 2011, 01:02

hi ,
i am doing analysis for steam turbine...so my inputs are
inlet pressure-125ata(12258310 pascals)
inlet temp -783K
inlet flow is 140 tonn/hr

now can any one tell me tht which type of boundary condition i have to choose...
coz i have pressure,temp and flow rate....so if i choose mass_inlet as my boundary type then where i have to give the inlet pressure...shall i give my inlet pressure in operating conditions...can any one suggest me reg this....

vishal_kumar · February 10, 2011, 02:06

hi,
can anyone take some effort to reply my query....thanks in advance....

Amir · February 10, 2011, 07:30

Hi Sudhir,
your problem is closed in incompressible region but in steam turbines compressibility effect is considerable! So you need to know the pressure where outflow exposed to.
e.g. consider a converge-diverge nozzle where mass flow rate and inlet pressure are known, by changing outlet pressure you will get different flow fields. therefore I think in compressible region your problem is not closed.

vishal_kumar · February 13, 2011, 11:35

Thanks amir...will try and let u know the result..

February 9, 2011, 01:02	boundary conditions	#1
vishal_kumar New Member sudhir Join Date: Feb 2011 Posts: 4 Rep Power: 4	hi , i am doing analysis for steam turbine...so my inputs are inlet pressure-125ata(12258310 pascals) inlet temp -783K inlet flow is 140 tonn/hr now can any one tell me tht which type of boundary condition i have to choose... coz i have pressure,temp and flow rate....so if i choose mass_inlet as my boundary type then where i have to give the inlet pressure...shall i give my inlet pressure in operating conditions...can any one suggest me reg this....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
symmetry boundary conditions in cfx	lost.identity	CFX	41	May 22, 2013 07:21
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	24	January 11, 2012 13:40
boundary conditions and mesh exporting	vaina74	Open Source Meshers: Gmsh, Netgen, CGNS, ...	2	May 27, 2010 09:38
Pressure boundary conditions	Lionel S.	Main CFD Forum	1	August 24, 2007 18:03
Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...	2	July 15, 2005 04:15

February 10, 2011, 02:06		#2
vishal_kumar New Member sudhir Join Date: Feb 2011 Posts: 4 Rep Power: 4	hi, can anyone take some effort to reply my query....thanks in advance....

February 10, 2011, 07:30		#3
Amir Senior Member Amir Join Date: May 2009 Location: Shiraz, Iran Posts: 720 Blog Entries: 1 Rep Power: 12	Hi Sudhir, your problem is closed in incompressible region but in steam turbines compressibility effect is considerable! So you need to know the pressure where outflow exposed to. e.g. consider a converge-diverge nozzle where mass flow rate and inlet pressure are known, by changing outlet pressure you will get different flow fields. therefore I think in compressible region your problem is not closed.

February 13, 2011, 11:35		#4
vishal_kumar New Member sudhir Join Date: Feb 2011 Posts: 4 Rep Power: 4	Thanks amir...will try and let u know the result..