|
[Sponsors] |
May 15, 2011, 23:22 |
Fluent, scale domain help!
|
#1 |
New Member
Bill
Join Date: Apr 2011
Posts: 2
Rep Power: 0 |
Hello everyone!
For a 3D computational domain like 1000m x 1000m x 50m, to simulate its velocity and temperature field, after setting boundary conditions and calculation, the scaled residuals are not convergent, just after several iteration steps, the lines are flat at the level of 1e-01. However, when scaling like 100m x 100m x 5m, and the same boundary conditions, the results are convergent very well. Somebody can tell me why, and how to set for the larger domain like 1000m x 1000m x 50m to make the calculation convergent well. Really frustrating for the problem. Really appreciating for your help. Bill |
|
May 18, 2011, 18:05 |
|
#2 |
New Member
mojtaba
Join Date: Nov 2010
Posts: 25
Rep Power: 15 |
you can decrease the under relaxations ....
|
|
May 18, 2011, 22:02 |
|
#3 |
New Member
Bill
Join Date: Apr 2011
Posts: 2
Rep Power: 0 |
Thanks guy.
I have found the problem. Just because I set one side of the square as air velocity inlet, and the others as pressure outlets. If there is only one pressure outlet opposite to inlet, with other two sides as walls, then the calculation is perfect. However, in fact, all of the other three sides should be pressure outlets, I will try further to solve the problem properly. Thanks for your attention. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain format problem on airfoil flow simulation | andrenonaka | CFX | 14 | December 7, 2015 01:42 |
Material identification between a flow domain and a porous domain | Ervideiro | CFX | 1 | June 1, 2010 10:50 |
How can I extend the domain in Fluent? | gabrielg | FLUENT | 1 | November 12, 2008 01:44 |
Fidap to Fluent | Ravi | FLUENT | 3 | July 10, 2008 14:31 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |