CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   FLUENT (https://www.cfd-online.com/Forums/fluent/)
-   -   Fluent Parallel Mode (https://www.cfd-online.com/Forums/fluent/88379-fluent-parallel-mode.html)

Dinocrack May 16, 2011 08:26

Fluent Parallel Mode
 
Hello

I am simulting a unsteady problem from a reactor, with two velocity inlets and, a two zones, where there is a interior face beetween them. And a pressure outlet.

I start with a steady solution, and from that i move to unsteady. For pressure discretization i use Presto and Momentum Quick. I run on parallel mode.

Everything looks fine, but near the 10000timesteps ocour an error from Divergence detected in AMG solver: pressure correction -> turning off correction scaling!
Divergence detected in AMG solver: pressure correction -> Increasing relaxation sweeps!

I close the program and after, trying to open give this error

"Building...
mesh
Cell Centroid is xc 1.993950 yc 1.463519 zc 1.365260
WARNING: no face with given nodes. Thread 7, cell 352956
Clearing partially read grid.

Error: Build Grid: Aborted due to critical error.

Error: Build Grid: Aborted due to critical error.
Error Object: #f"


The mesh was fine...but i still dont understand where is the problem and now i can't run in parallel mode. I star the same simulation but with lower discretizations. I will try some stabilization, and then change to presto and quick again.

Anyone can help me? I dont know why this is not workting for parallel mode...


All times are GMT -4. The time now is 10:33.