|June 6, 2011, 22:32||
Geomtery for Hydroplanning Simulation
Join Date: Dec 2010
Posts: 4Rep Power: 7
I have to calculate forces (Lift and drag) on moving tire of the car due to dynamic hydroplanning. The problem is that it involves multiphase flow (Air + Water) and I am new to this field and stuck withe geometery creation for the above problem.So, I have following questions ;
1-How to create two inlets one for (Air and other for Water)
2-Can we split the enclosure lets say in two parts upper and lower so that It can create two Inlets?if so how to do that?
Appreciate your suggesions.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Why my simulation not agree with the wind tunnel experiment||zhaowei||CFX||4||July 11, 2015 03:36|
|Solar Radiation in OpenFOAM||plainstyle||OpenFOAM Running, Solving & CFD||15||July 8, 2014 04:43|
|Simulation of a complex wing in solidworks flow simulation||niels1900||FloEFD, FloWorks & FloTHERM||6||April 20, 2011 10:44|
|Continuous vs interrupted simulation||sega||OpenFOAM Running, Solving & CFD||4||November 3, 2008 15:29|
|strange simulation error||Ralf Schmidt||FLUENT||2||May 4, 2007 13:02|