|
[Sponsors] |
June 13, 2011, 11:16 |
Dynamic mesh for tetrahydral elements
|
#1 |
New Member
Join Date: Apr 2011
Posts: 4
Rep Power: 15 |
Hi
I am trying to simulate a case of withdrawing reservoir fluid through a plunger. I am trying to apply moving mesh at the plunger head that is moving away at constant velocity (UDF). Tetahydral mesh is utilized. I declard the outlet bounday as wall and used dynamic mesh there. The method I tried is 'Layering' as well as 'remeshing'. But, my elements at the layer attached to the moving boundary get elnogated in transient analysis. Thus aspect ratio goes on increasing too high that the solution diverges at the moving bounday. What options/sizing function shall I apply. Any tutorial on this topic. urgent hepl is required. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
Dynamic mesh update problem. | David | FLUENT | 3 | March 15, 2012 05:02 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[mesh manipulation] Dynamic Mesh Diffusivity Problem | dancfd | OpenFOAM Meshing & Mesh Conversion | 0 | August 29, 2010 11:50 |
Some questions about mesh updating in dynamic mesh technique | lzgwhy | Main CFD Forum | 0 | June 14, 2009 08:01 |