|June 18, 2011, 06:53||
Join Date: Jun 2011
Posts: 76Rep Power: 7
I have a simulation of a flow over a body at Re=100000. I'm going to deal it using the standar k-e and the standard near-wall treatment.
Reading the FLUENT user's guide, I note a value of y+ between 30 and 300-500 must be got in order to apply the log-law, what I want.
Well, I don't know how to mesh it since the cells within the boundary layer would be very larges and I'd like to get the next ones -out of the boundary- much smallers to get better results...
Finally, I have read about a "scalable wall function", but I don't know if it's able to use it in this case.
Could anyone help me?? I don't know if I am in the correct way...
Thanks a lot!
|mesh, near wall mesh, standard k-e|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question about standard wall functions.||George||FLUENT||1||February 16, 2007 17:38|
|about the unit of the standard state enthalpy!!||KEVIN||FLUENT||3||March 25, 2004 09:32|
|Standard wall function vs Two layer model||C. ORTEGA||FLUENT||0||July 7, 2003 08:35|
|table and standard inlet condition||N.A. Beishuizen||CD-adapco||0||August 29, 2001 05:22|
|Time-plot of standard deviation of temperature||rakib||FLUENT||0||June 29, 2000 13:50|