|June 22, 2011, 09:38||
heat conduction through the wall
Join Date: May 2011
Posts: 3Rep Power: 6
i have to analysis some phenomenon occuring inside a fuel tank(cylinder and hemisphere ends) by heat transfer through the wall of the tank.
i setup a specific-temperature boundary condition on the wall of the tank.
but i cannot observe any phenomenon representing heat conduction into the fluid inside the wall
the wall is just a closed surface
|boundary condition, conduction, fluent, heat|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wall Heat Flux not a listed variable||mike||CFX||8||February 5, 2009 14:32|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Heat conduction through solid rib in periodic duct||Dieter Fauconnier||FLUENT||0||October 7, 2004 08:22|
|wall conduction, UDF||sudh||FLUENT||0||June 28, 2004 08:09|
|Wall heat flux||cujo||CFX||3||November 6, 2002 04:43|