|
[Sponsors] |
November 20, 2023, 20:06 |
nonuniform heat release rate
|
#1 |
New Member
wq yang
Join Date: Oct 2023
Posts: 7
Rep Power: 2 |
Dear Sir/Madam,
I was trying to perform some simulations on combustion. However, when I used the adaptive mesh in fluent, I got normal contours of all variables except heat of reaction. What's more, the heat of reaction was abnormal again near the regional border of coarse grids and refined grids. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with total heat transfer rate | aswathy_raghu | FLUENT | 9 | April 21, 2022 10:36 |
Heat release rate (HRR) calculation in fluent | MAC88 | FLUENT | 1 | April 28, 2021 22:10 |
How can I get heat release rate in Converge?(not based on engine condition) | Flashboiling | CONVERGE | 1 | August 21, 2019 03:50 |
partially premixed combustion heat release rate per cell | sqek | FLUENT | 0 | May 16, 2017 08:04 |
Heat Generation rate in W/m³ | ashghan | OpenFOAM Programming & Development | 0 | June 27, 2014 05:42 |