|July 1, 2011, 06:42||
Error when input new parameter in Fluent
Join Date: Jun 2011
Posts: 58Rep Power: 6
It is quite strange for me when I try to use 'input new parameter' in fluent.
For example, when setting up the boundary condition, select inlet and click edit. Choose velocity as magnitude and direction. Then click the drop list on the right of velocity magnitude and choose input new parameter. A new window comes out and input any value such as 10 in the current value, then click OK. However, no new parameter of velocity has been added!
'Interesting' thing is, when I click cancel rather than OK, a new parameter with value of 0 will be added!
To set a new input parameter is a simple task but I don't know why it happens so difficult to me....
|Thread||Thread Starter||Forum||Replies||Last Post|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|few quesions on ANSYS ICEMCFD and FLUENT||Prakash.Paudel||ANSYS||0||August 12, 2010 12:07|
|Fluent 6.3.26 vs 12.1 and partition method||Anorky||FLUENT||0||April 27, 2010 10:55|
|solving ocean wave with Fluent or CFX?||gholamghar||Main CFD Forum||1||March 21, 2009 13:49|
|TUI Mass-flow-rate input with Fluent 6.1||Jeremy||FLUENT||0||December 12, 2005 16:00|