 |
 |
 |
|
|
|
[Sponsors] | ||||
July 9, 2011, 01:29
|
Node Number And Results
|
#1 |
|
New Member
ZenCef
Join Date: Feb 2010
Posts: 23
Rep Power: 16  |
Hi,
I have a simple 3D steady state heat transfer problem. I dont use fluid, all cells are solid and i gave them convection BC. All methods are same and i only increase the node number to control the mesh independence. Solution is converged after 2 iteration but the results ( heat flux and temperature) are also increase with the node number. Results increment is too high (e.g. 6 °C) for this simple problem. Could you help me, what is my mistake? Best regards.. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
| Exporting results and Mach number calculation | pawan1989 | CFX | 0 | July 14, 2010 13:05 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
Linear Mode
