CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   remeshing grid cannt be split (http://www.cfd-online.com/Forums/fluent/91311-remeshing-grid-cannt-split.html)

sun_rain August 6, 2011 23:13

remeshing grid cannt be split
 
Hello, I met a question in the remeshing grid. The tri grid can not be split when the length of the grid is out of the maximum length scale, and it is only stretched.
Who has met such question?
Can you give q hand?
The case and UDF profiles as follows.
Thanks.

sun_rain August 6, 2011 23:27

Quote:

Originally Posted by sun_rain (Post 319158)
Hello, I met a question in the remeshing grid. The tri grid can not be split when the length of the grid is out of the maximum length scale, and it is only stretched.
Who has met such question?
Can you give q hand?
The case and UDF profiles as follows.
Thanks.

sorry, I cant send the attachment.
It is a cylinder, the total height is1mm, the radius is 30mm. The top 0.5mm is tri grid while the bottom 0.5mm is quad. A interface connect the two cylinder.
The two interface faces and the bottom face of the cylinder are downstream with the velocity of -0.001 in Z axis.

snailstb November 1, 2011 05:23

Quote:

Originally Posted by sun_rain (Post 319159)
sorry, I cant send the attachment.
It is a cylinder, the total height is1mm, the radius is 30mm. The top 0.5mm is tri grid while the bottom 0.5mm is quad. A interface connect the two cylinder.
The two interface faces and the bottom face of the cylinder are downstream with the velocity of -0.001 in Z axis.

Have you solve this problem? I also meet the same problem. Mesh can not be remeshed, but only strech till negtive volumn exists. Do you have some points for it. Waiting for your help.


All times are GMT -4. The time now is 10:06.