|August 11, 2011, 18:14||
quick divergence in air-water multihpase system?
Join Date: Apr 2009
Posts: 16Rep Power: 8
I am modeling an air-water system using Eulerian multiphase model, and the air is primary phase and water is secondary phase. But my calculation diverges very quickly. I can only run it if I decrease the water droplet size below 200 microns and increase the density of air dramatially (at least 5 times). There is a pretty strong swirling flow in my geometry and my mesh quality is good.
Does anybody have similar experience with this? What's the reason for that?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Heat Transfer Coeff on the water air interface||Anton||Main CFD Forum||3||June 2, 2010 01:49|
|Setfields inoutlet and water and air patches||erik023||OpenFOAM Pre-Processing||1||September 29, 2008 10:05|
|Air bubble in water||liu||OpenFOAM Running, Solving & CFD||3||April 16, 2008 12:24|
|incompressible air flow in air intake system||reza besharati||Main CFD Forum||4||June 4, 2001 20:23|