|
[Sponsors] |
October 30, 2020, 00:39 |
Source term on adiabatic wall
|
#1 |
Senior Member
Arun raj.S
Join Date: Jul 2011
Posts: 194
Rep Power: 14 |
Hello everyone,
I have 10mx10m adiabatic wall as one of the boundary condition. I would like to know what will happen if I apply heat source term on specific region (center) of the adiabatic wall. The heat source term is applied only for a size of 1mx1m area. Does this region will be considered as adiabatic? Thank you. Please share your knowledge as it will be very help for me. Last edited by arunraj; October 30, 2020 at 01:57. |
|
November 2, 2020, 09:01 |
|
#2 |
Senior Member
Moritz Kuhn
Join Date: Apr 2010
Location: Germany, Dresden
Posts: 207
Rep Power: 16 |
In this 1mx1m area the wall will be not adiabatic anymore as the heat will be transferd to your fluid.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] Installation Problem with OF 6 version | Aurel | OpenFOAM Community Contributions | 14 | November 18, 2020 17:18 |
what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 02:22 |
[Other] How to use finite area method in official OpenFOAM 2.2.0? | Detian Liu | OpenFOAM Meshing & Mesh Conversion | 4 | November 3, 2015 04:04 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |