|September 1, 2011, 20:47||
Wall Zone References
Join Date: Sep 2011
Posts: 1Rep Power: 0
So I have a model of an airplane wing that I am trying to do a CFD test on. It goes through loading the geometry and meshing. I set up the conditions for the CFD test, then initialize and calculate. It converges the calculations perfectly. However, when I try to return to monitors for lift and drag, I cannot find a reference for the wall zones. Is there a way to manually create these before the test?
I exported the geometry form Pro/E as an .stp if that matters (I don't believe it should).
Edit: Also, I realized in the Boundary Conditions options, I was changing the wall boundary to a pressure-far-field. Is there a way to create a new pressure far field option in the Boundary Conditions options?
|wall reference monitors|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Patches for OpenFOAM 1.7 on MacOS X||gschaider||OpenFOAM Installation on Windows, Mac and other Unsupported Platforms||101||September 21, 2011 06:37|
|UDF for wall slipping||HFLUENT||Fluent UDF and Scheme Programming||0||April 27, 2011 13:03|
|TGridFluent mesh with internal by prism layer and internal face for diagnostic||sponiar||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||March 30, 2009 16:02|
|T junction - meshing wall zone in Gambit||John||FLUENT||3||August 29, 2005 11:09|
|Fluent creating wall zone on mesh import?||Mark||FLUENT||4||April 4, 2005 08:14|