|September 25, 2011, 09:30||
Gambit problem: How to place axis for a hollow cylinder
Join Date: Sep 2011
Posts: 1Rep Power: 0
I would like to draw a hollow cylinder:
For r<r_int, it's empty
For r_int<r<r_out, it's solid region.
I would like to use the axi-symmetric model:
The x axis is used as the axis. An edge is draw along the x axis and assign in "zone" as axis.
A rectangle is drawn above the x axis to represent the hollow cylinder
But when I tried to export the mesh, the axis is ignored:
"Boundary Entity axis does not contain any valid entity and is not written".
Anyone has hint how to solve this?
Do let me know if the problem is not made clear.
|September 28, 2011, 01:18||
Join Date: Mar 2009
Posts: 3,145Rep Power: 32
Somebody had also this problem, but no feedback on what I proposed...
axis Boundary conditions
The problem is that you don t have any adjacent cells on revolution-axis
Perhaps you can define and mesh the solid domain, and export it (take care defining it as solid in Continnum type), but I never tried this
Else you could extend your cylinder (even if it is not in your interest) and adjust it with a not-hollow cylinder. With this not-hollow cylinder you will be able to define your axis
In memory of my friend Hervé: CFD engineer & freerider
Last edited by -mAx-; September 28, 2011 at 01:45.
|axis, gambit, hollow cylinder|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with Injection in engine Cylinder||mayur||FLUENT||8||January 14, 2010 21:09|
|Problem starting Gambit||ViHAR MALViYA||FLUENT||0||November 10, 2006 11:26|
|solving airfoil like square cylinder problem?||zonexo||Main CFD Forum||1||May 27, 2006 15:16|
|Problem when I run old gambit jou file with new||xfshi||FLUENT||0||March 31, 2005 13:03|
|GAMBIT meshing problem||Gauthier Lambert||Main CFD Forum||1||August 3, 2000 09:22|