How to check cell skewness

newbie_81 · October 3, 2011, 07:55

Hi

I created my mesh by using Gridgen and imported the mesh into fluent.I tried to check the skewness quality of my hex mesh but when I clicked on report quality,I got only the information about cell squish.Can anyone advise me on this?

-mAx- · October 3, 2011, 08:52

I would be suprised if you don't have any panel about mesh quality in Gridgen
>> Check your mesh in your mesh-software

newbie_81 · October 3, 2011, 18:35

Thanks for the advise.Even though I can check mesh quality in Gridgen,I just wonder why fluent didn't show me the skewness quality of my hex mesh.Perhaps my operation of fluent was inappropriate or fluent itself does not report skewness quality(eg max and min value)

-mAx- · October 4, 2011, 01:45

I don't have Fluent anymore, but I can remember something about skewness in display/contour/grid.

newbie_81 · October 8, 2011, 00:34

thank you very much for the advice.

October 3, 2011, 07:55	How to check cell skewness	#1
newbie_81 New Member Join Date: May 2011 Posts: 8 Rep Power: 14	Hi I created my mesh by using Gridgen and imported the mesh into fluent.I tried to check the skewness quality of my hex mesh but when I clicked on report quality,I got only the information about cell squish.Can anyone advise me on this?

October 3, 2011, 08:52		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	I would be suprised if you don't have any panel about mesh quality in Gridgen >> Check your mesh in your mesh-software __________________ In memory of my friend Hervé: CFD engineer & freerider

October 4, 2011, 01:45		#4
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	I don't have Fluent anymore, but I can remember something about skewness in display/contour/grid. __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cell Reynolds Number	laliong	Main CFD Forum	12	September 17, 2019 03:18
Y and Cell Aspect Ratio	gdbaldw	OpenFOAM Running, Solving & CFD	11	December 6, 2016 11:58
[Netgen] Import netgen mesh to OpenFOAM	hsieh	OpenFOAM Meshing & Mesh Conversion	32	September 13, 2011 05:50
Maximum Cell Skewness	killtimm	FLUENT	0	June 27, 2010 07:34
cell skewness	arunjingade	STAR-CCM+	2	June 23, 2010 07:37

October 3, 2011, 18:35		#3
newbie_81 New Member Join Date: May 2011 Posts: 8 Rep Power: 14	Thanks for the advise.Even though I can check mesh quality in Gridgen,I just wonder why fluent didn't show me the skewness quality of my hex mesh.Perhaps my operation of fluent was inappropriate or fluent itself does not report skewness quality(eg max and min value)

October 8, 2011, 00:34		#5
newbie_81 New Member Join Date: May 2011 Posts: 8 Rep Power: 14	thank you very much for the advice.