How to make a region to patch a bubble

japanese student · December 30, 2015, 11:11

Hello.
If you answer my question, I really appreciate your kindness.

My question; I can't make a region to patch a bubble in the most finest grids.

I study bubble dynamics by using VOF method.
To meke the calculation cost low I used three types grids like Figure.1.
To make the grids I used adjust option in Fluent.

Thank you for your reading.

ErdemKaya · December 30, 2015, 13:20

Just an idea, you can add an inlet at below of finer grid, you can define only air phase that inlet. And mass-flow (or velocity) inlet is bigger than 0 for a short time.

Or you can add different zone in design modeler inside finer grid zone. Similar with this:

https://www.youtube.com/watch?v=nN-KO6cEskE

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with chtMultiregionFoam radiation boundary condition	baran_foam	OpenFOAM Running, Solving & CFD	10	December 17, 2019 17:36
Near wall treatment in k-omega SST	Arnoldinho	OpenFOAM Running, Solving & CFD	38	March 8, 2017 13:48
[snappyHexMesh] Multi region meshing & recovering the original patch names	fluidpath	OpenFOAM Meshing & Mesh Conversion	4	May 19, 2013 19:13
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12

December 30, 2015, 13:20		#2
ErdemKaya New Member Erdem Kaya Join Date: Dec 2015 Posts: 7 Rep Power: 10	Just an idea, you can add an inlet at below of finer grid, you can define only air phase that inlet. And mass-flow (or velocity) inlet is bigger than 0 for a short time. Or you can add different zone in design modeler inside finer grid zone. Similar with this: https://www.youtube.com/watch?v=nN-KO6cEskE