|
[Sponsors] |
October 29, 2011, 17:45 |
suction pipe in reservoir
|
#1 |
New Member
Mahdi
Join Date: Nov 2010
Posts: 7
Rep Power: 15 |
hello friends,
I am new to fluent and also new here but I am glad to see CFD men here! well, I am simulating flow in a suction pipe in a reservoir. during the iteration these messages appear: -reversed flow in 360 faces on pressure inlet -turbulent viscosity limited to viscosity ratio of 1e+5 in 7156 faces. the iteration converged for residuals 1e-3 but these messages didn't vanished! so what can I do to solve these problems? it is good to say that the boundary condition for free surface has set to pressure inlet=0 and the boundary condition for the outlet(where the flow pours out from the pipe) has set to velocity inlet=-2 thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
pipe in pipe heat exchanger | JohannV | FLUENT | 3 | December 3, 2009 02:53 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |