|
[Sponsors] |
setting volume monitor in just a fragment of a cell zone?? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 7, 2011, 08:09 |
setting volume monitor in just a fragment of a cell zone??
|
#1 |
Member
Join Date: May 2010
Posts: 57
Rep Power: 15 |
Dear all,
I am modelling a Wankel engine gas circuit which is essentially a single volume zone, not split by the rotor seals as this would mess up dynamic mesh (i think). What I would like to do is to define 2-3volume monitors in the volumes created by each of the 3 flanks of the triangular piston. These regions are not represented by any named zones. Any ideas on how to do it? Thanks a lot. Best, Thanos |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] Setting a boundary layer as a function of pressure or specific volume | Ginganinja | ANSYS Meshing & Geometry | 3 | February 16, 2011 01:48 |
Ultra high temperature? | bk | Siemens | 2 | July 19, 2005 00:01 |
calculate cell volume, center...? | Paul | Main CFD Forum | 5 | June 21, 2003 12:55 |
How to caculate cell volume | Tareq Al-shaalan | Main CFD Forum | 2 | November 4, 2002 08:48 |
Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |