|November 7, 2011, 09:09||
setting volume monitor in just a fragment of a cell zone??
Join Date: May 2010
Posts: 57Rep Power: 7
I am modelling a Wankel engine gas circuit which is essentially a single volume zone, not split by the rotor seals as this would mess up dynamic mesh (i think).
What I would like to do is to define 2-3volume monitors in the volumes created by each of the 3 flanks of the triangular piston.
These regions are not represented by any named zones.
Any ideas on how to do it?
Thanks a lot.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[GAMBIT] Setting a boundary layer as a function of pressure or specific volume||Ginganinja||ANSYS Meshing & Geometry||3||February 16, 2011 02:48|
|Ultra high temperature?||bk||CD-adapco||2||July 19, 2005 00:01|
|calculate cell volume, center...?||Paul||Main CFD Forum||5||June 21, 2003 12:55|
|How to caculate cell volume||Tareq Al-shaalan||Main CFD Forum||2||November 4, 2002 09:48|
|Sliding mesh error||Karl Kevala||FLUENT||4||February 21, 2001 16:52|