 |
 |
 |
|
|
|
[Sponsors] | ||||
November 21, 2011, 09:03
|
Raiation modelling problem
|
#1 |
|
New Member
Join Date: Oct 2009
Posts: 29
Rep Power: 16  |
Hi Guys,
A simple radiation modelling problem. The problem is from incropera 5th Edition Example 13.3. A cylinderical cavity, side wall at 1623K and bottom at 1923K, and top is the atmosphere at 300K. Required heat flux through the top. I used S2S model, the view factor calc is the same on Fluent and the book, but the heat flux from Fluent Report-->Fluxes -->heat transfer rate is very diferent from the book. Can some one shade a light on this. Is Fluent heat flux calc as mentioned reliable. q_sideWall_Top=1639W, q_sidewall_Top=205W (book) From Fluent, 52 and 1790W resp. Taw |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 04:36 |
| Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
| Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
| modelling a classroom using Airpak! | Amid | FLUENT | 0 | October 20, 2005 16:30 |
| Unsteady modelling - AMG divergence + acoustics | Neville | FLUENT | 0 | September 3, 2004 00:21 |
Linear Mode
