 |
 |
 |
|
|
|
[Sponsors] | ||||
November 23, 2011, 00:47
|
run time error
|
#1 |
|
New Member
M Umar Fraooq
Join Date: Oct 2011
Posts: 3
Rep Power: 14  |
hello!
i am using workbench 13 for my project for my BE degree. I have my model in design modeler by points then lines were made from points and then surfaces were made and then single body was made after that meshing was done and when i went to setup for fluent results its was not readable and a message was displayed as run time error can anybody guide me to solve this problem. is there is any problem in modeling or meshing. i will be very thank full to you. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| CGNS lib and Fortran compiler | manaliac | Main CFD Forum | 2 | November 29, 2010 06:25 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
Linear Mode
