|November 29, 2011, 05:16||
Heat source at coupled interface
Join Date: Nov 2011
Posts: 2Rep Power: 0
We are working on the thermoelectric generator, where we want to specify the Peltier effect at a interface between two solids. Since the two solids are of different temperatures we must allow conduction between them. Our question is: how do you add the heat source at this boundary? Using the coupled model only allow us to specify the heat generation in W/m^3 but we want to specify it in W/m^2....
Anyone has an idea of how to do this?
Thanks in advance!
The frustrated ones.
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4foam building problem||GGerber||OpenFOAM Installation||54||April 24, 2015 16:02|
|No results for solid domain||Gary Holland||CFX||10||March 13, 2009 04:30|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Missing heat source||Phil||FloEFD, FloWorks & FloTHERM||9||June 19, 2008 10:33|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|