|
[Sponsors] |
November 30, 2011, 09:21 |
Boundary condition
|
#1 |
New Member
lili pak
Join Date: Apr 2010
Posts: 1
Rep Power: 0 |
I was using Gambit and fluent before, recently I switched to Ansys 13.
I have a mixing system with two impellers; one in center and one with the close clearance with tank wall and bottom. therefore I have three zones: two around impellers and one stationary zone. I have imported my geomtry from CAD software as a step file to DM. I first deleted the tank thicknes, then unite the impellers with shafts which will have same boundary condition and then using subtract, try to make 6 volumes, I did same procedure in Gambit ... therefore I have 6 volumes and everything seems fine. Then meshing part and there I specify the symmetry and tank wall as I needed them for boundary conditions. again everything seems fine. when I go to the fluent, in cell zones I have 6 volumes but in boudary condtion I have 6 items with interior type and agin same 6 items with wall type ... while 3 of them are really wall not interior and three of them are interior ... please help me how I can solve this problem Priority: Please use ANSYS FTP (ftp://ftp.ansys.com/incoming/techsupp) for attachments greated than 20 MB. Any attachments larger than 20 MB will be removed. Attachments |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
Boundary Conditions | Thomas P. Abraham | Main CFD Forum | 20 | July 7, 2013 06:05 |
Setting outlet Pressure boundary condition using CAFFA code | Mukund Pondkule | Main CFD Forum | 0 | March 16, 2011 04:23 |
How exactly the "pressure outlet" bdry condition compute properties on the boundary? | yating9901 | FLUENT | 3 | June 28, 2010 13:26 |
How to set boundary condition in Fluent for the fo | Peiyong | FLUENT | 1 | November 10, 2006 12:44 |