 |
 |
 |
|
|
|
[Sponsors] | ||||
December 5, 2011, 10:01
|
Eulerian model, boundary condition
|
#1 |
|
New Member
abolfazl
Join Date: Mar 2011
Posts: 4
Rep Power: 15  |
Hi
I am solving an air+solid case with Eulerian model, with two outlets, For one of the outlets the set up is for both the air and particle but how can I set the other outlet just for the solid particles and not for air? Thanks in advance for your reply |
|
|
|
|
|
December 5, 2011, 23:58
|
Hi
|
#2 |
|
Senior Member
shoeb khan
Join Date: Nov 2011
Posts: 179
Rep Power: 14 |
In outlet use back flow volume fraction of secondary phase as one.
SHK |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Epsilon boundary condition for walls in LamBremhorst LowRe model | maruthamuthu_venkatraman | OpenFOAM | 1 | April 21, 2019 06:25 |
| Boundary condition issue in multi-phase model | carl_r | CFX | 0 | August 4, 2010 19:03 |
| boundary condition_vof model | garima chaudhary | FLUENT | 0 | October 9, 2007 02:08 |
| Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
