|December 13, 2011, 00:09||
Join Date: Jun 2009
Posts: 138Rep Power: 8
I have divided the entire domain into number of zones and meshed them separately. These zones include fluids as well as solids. Then these zones are linked through mesh interface in FLUENT. I believe the interface is done properly as the properties are exchanged between them for steady state thermal analysis.
Now after this I saved the cas and dat file which was again reopened in new fluent launcher where i found the error of "zone surface can not create surface from sliding interface zone" and "Error: CDR: invalid argument : wrong type [not a pair]
Error Object: #f".
Can you please tell me where is the issue?
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Problem making structured mesh on a surface||froztbear||ANSYS Meshing & Geometry||4||November 10, 2011 09:52|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|increasing mesh quality is leading to poor convergence||tippo||CFX||2||May 5, 2009 10:55|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|