|December 13, 2011, 20:48||
Daniel J Sullivan
Join Date: Dec 2011
Posts: 1Rep Power: 0
I am trying to get myself up to speed on using Fluent from within ANSYS Workbench (version 12.1).
I have looked for materials that provide some step-by-step examples that can provide some "best practices" and explanations as to some of the methodology used in both the design and meshing applications. I find that I keep running up against small items that are stopping me dead in my tracks. Ideally I would like to be able to begin with "simple" 2D problems such as a backward facing step,
flow over a cylinder and
flow past a flat plate oriented perpendicular to the flow.
For each of these, I have been able to obtain "ok" results but usually end up with solutions that don't converge when I attempt to refine my results.
BTW - I am familiar with tutorials from both
and Penn State:
I guess I am looking for the "missing manual..."
Any suggestions (short of going to a "training" session) would be greatly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Charpy Impact Analysis Of Composite Materials||dineshkumaranbu||ANSYS||0||November 13, 2011 11:00|
|Selecting Materials in WB 12.0 plz HELP!!||BrianK||ANSYS||2||October 13, 2010 14:28|
|Constant velocity of the material||Sas||CFX||15||July 13, 2010 08:56|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|Reaction help!!||Harry||CFX||4||October 30, 2008 11:11|