cfd 6.3.26
 

hi ,
i am having problem in sliding mesh technique ( train moving in tunnel {2D analysis}) ,plz can any one help me
i had done following steps
1. i made two mesh files independently in gambit.
2. i export them into fluent one by one
3. then i use FUSE , command of fluent to combine them together.
4. then i use display, to see the model. after then i use grid check . it was done.
5. now i had to use cell zone conditions , but i am not able to do that.
plz can any tell me am i doing perfectly and how to proceed further .

sliding mesh
 

hello
plz help me in sliding mesh , i am not able to solve it . my email id is sheikhnasir39@gmail.com
thanks