|
[Sponsors] |
January 31, 2012, 10:52 |
transient batch file
|
#1 |
Member
Stephan Langenberg
Join Date: Sep 2011
Location: Germany
Posts: 73
Rep Power: 14 |
Hi, everyone,
Trying to run a transient simulation with fluent I used this batch file: ;fluent 3ddp -g <batchfile1>& output& ; ; Read case file and data file rc SYS-2.2.cas rd SYS-2.2.dat /solve/set/time-step 0.1 /solve/dual-time-iterate 4960 2 ; Write data file and case file wc SYS-2.2_ende.cas wd SYS-2.2_ende.dat ; Exit FLUENT exit The project started and runs very well (monitors updated ervery time step etc.). After the last iteration the "output file" wrote: "Halting due to end of file on input." - no case file and data file were written. I haven't got an idea where the mistake could be.- Maybe someone in this forum sees a mistake, or has got an idea. Best regards, Jim |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
paraview installation woes | vex | OpenFOAM Installation | 15 | January 30, 2011 07:11 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |