 |
 |
 |
|
|
|
[Sponsors] | ||||
February 8, 2012, 10:17
|
grid refinement problem fluent 6
|
#1 |
|
New Member
Koen Achten
Join Date: Aug 2011
Posts: 4
Rep Power: 14  |
hello,
I'm using Fluent 6 with a mesh generated in Gambit. I'm simulating an NACA airfoil with the standard k-epsilon model. I've done some calculations but my results ain't good. I made a XY plot of the y+ values. I read the the y+ must be bigger than 30. When I want to refine the grid (adapt -> y+/y*-> mark for refinement. None of the cells are marked, only a few coarsened. What can I do make my mesh/simulation correct? Thanks in advance!! Koen |
|
|
|
|
|
February 9, 2012, 11:03
|
|
#2 |
|
New Member
Koen Achten
Join Date: Aug 2011
Posts: 4
Rep Power: 14 |
anyone an idea maybe please?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| HELP! grid check failed in parallel fluent | restart | FLUENT | 0 | March 5, 2011 09:55 |
| [ICEM] [FLUENT] 2D Geometry problem when exporting to Fluent - Unwanted walls | MikeTichondrius | ANSYS Meshing & Geometry | 1 | February 9, 2011 13:31 |
| Problem in Tutorial problem of fluent | Phanindra | FLUENT | 5 | April 17, 2007 09:57 |
| Problem with Grid display | avinash | FLUENT | 2 | December 8, 2006 13:49 |
Linear Mode
