 |
 |
 |
|
|
|
[Sponsors] | ||||
February 11, 2012, 13:52
|
converting wall to interface
|
#1 |
|
Member
Abdulqadir Aziz
Join Date: Jan 2012
Posts: 45
Rep Power: 0  |
Hi everyone,
I'm trying to run an mrf simulation. It's basically a wind turbine in a square wind tunnel. Around the wind turbine, I have a cylindrical volume for the rotational reference frame. In gambit, I had defined the interface as wall prior to export. The problem now is that I am unable to convert the wall into an interface boundary condition in fluent! Somehow the wall only has the other options of fan, interior, porous and wall. I looked at the other walls, and those had all the fluent boundary condition options. What gives? I'm stumped. |
|
|
|
|
 |
| Tags |
| fluent, interface, mrf, wall boundary conditions |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 06:23 |
| Patches for OpenFOAM 1.7 on MacOS X | gschaider | OpenFOAM Installation | 101 | September 21, 2011 05:37 |
| Expression with time function | kestasposkus | CFX | 28 | July 24, 2011 06:47 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| Problem Interface Solid Fluid with wall velocity Solver v12 | hills1 | CFX | 2 | October 12, 2009 05:36 |
Linear Mode
