 |
 |
 |
|
|
|
[Sponsors] | ||||
February 12, 2012, 00:54
|
inlet for turbulent boundary layer
|
#1 |
|
New Member
wen xin
Join Date: Feb 2012
Posts: 1
Rep Power: 0  |
hi, all,
I am using FLUENT to simulate turbulent boundary layer, the turbulent intensity is 0.5%. To set the velocity inlet, I use UDF to profile k and epsilon at inlet. K and epsilon are calculated by turbulent intensity and velocity magnitude which will increase according to y+. However, the result is not good, can anybody give some suggestions? Many thanks |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh | tomyangbath | FLUENT | 16 | January 18, 2012 04:47 |
| [GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
| Pulsating flow with non-reflective inlet boundary | cc1000 | CFX | 6 | April 27, 2009 08:10 |
| specifyying a boundary layer thickness at inlet | Fayyaz Hussain ASGHAR | FLUENT | 0 | June 24, 2007 06:08 |
| Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |
Linear Mode
