 |
 |
 |
|
|
|
[Sponsors] | ||||
February 12, 2012, 04:01
|
iterations not calculated
|
#1 |
|
Member
Abdulqadir Aziz
Join Date: Jan 2012
Posts: 40
Rep Power: 3  |
Hi everyone,
I'm attempting to run a periodic mrf of a wind turbine. I'm pretty sure all the settings are correct (periodic set to rotational, rotor zone set to mrf, etc). But fluent just wont iterate. It shows the iterating... dialogue, but that's all! I'm really frustrated right now since I couldn't find any solution to this problem. Could someone out there help me please? 
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 7 | March 15, 2013 06:08 |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 9 | January 3, 2012 08:06 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM | 6 | April 12, 2011 11:24 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
Linear Mode
