CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Need help with creating a sliding interface (

cp2000 February 14, 2012 13:24

Need help with creating a sliding interface

I have a fluid that is divided into different domains for the purpose of applying different sized mesh to each zone. I made the fluid geometry as a single 2d part, and used projection lines to create the different domains in Ansys Workbench. I now want to import my mesh into Fluent and make one of the interior domains a dynamic mesh zone, and the other domains stationary. Since I have a dynamic mesh zone that is surrounded by a stationary mesh, do I have to create a sliding interface? If so, how do I create one? I think I need to create bounds for each interior subdomain and specify them as interfaces, but I don't know how to create boundaries to my interior subdomain. Thanks for any help you can provide.


esho March 15, 2016 20:05

hi Did you manage to solve this problem? If so could you tell me whether a sliding interface is needed?
I have the same question you had a couple of years back! :)
Any help is appreciated. Thank you

All times are GMT -4. The time now is 11:48.