|
[Sponsors] |
October 1, 2013, 07:07 |
cooling of the brass plate
|
#1 |
Member
|
HI every one
I'm trying to simulate the below problem large brass plates of 4-cm thickness that are initially at a uniform temperature of 20 C are heated by passing them through an oven that is maintained at 500 C. The plates remain in the oven for a period of 7 min. Taking the combined convection and radiation heat transfer coefficient to be h 120 W/m2 · C, determine the surface temperature of the plates when they come out of the oven. answer for this problem is 282 C. Which boundary condition in fluent should is use |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flat plate analysis in cfx | hamed.majeed | CFX | 14 | February 4, 2015 07:07 |
2D cooling of wavy plate | Vidit Sharma | FLUENT | 9 | August 15, 2012 08:24 |
HELP! Flow over both sides of a plate. | farocean97 | Main CFD Forum | 0 | September 12, 2011 10:57 |
heat transfer on dimpled plate | mech | FLUENT | 4 | February 6, 2007 15:15 |
Parallel Plate Rheometer vs Cone & Plate | beginner | Main CFD Forum | 0 | March 19, 2003 11:49 |