CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Fluent default surface boundary condition (http://www.cfd-online.com/Forums/fluent/97814-fluent-default-surface-boundary-condition.html)

lalupp February 26, 2012 09:20

Fluent default surface boundary condition
 
Hi

Suppose we have a unnamed meshed surface in gambit and when this is imported in fluent 6.3, this would be assigned as wall (default) boundary zone
Is there any way to set default boundary zone as interior in FLUENT

I have a large mesh with lot of features naming each surface ,I found very difficult

Any suggestion

Zigainer February 27, 2012 03:41

I don't know if you can change the default settings, but otherwise you could wirte a journal-file which changes all boundary conditions to interior (if you knwo all the names).

delaneyluke February 27, 2012 04:30

FLUENT will name wall (default) to those surfaces which have a mesh only on one side. FLUENT will name interior (default) to those surfaces that have mesh on both sides. In case you find an interior surface named as a wall then you need to fuse the 2 surfaces that are identical but belong to 2 different volumes.

Regards
Luke


All times are GMT -4. The time now is 20:17.