|February 28, 2012, 00:31||
Cyclone efficiency in DPM
Join Date: Oct 2011
Location: Tokyo, JAPAN
Posts: 66Rep Power: 5
i want to find efficiency of cyclone.
i have following issues.
1. in DPM tab i found three types of Boundary conditions escape, trap,
reflect. for inlet of cyclone i have used trap condition, for dust
outlet i have used trap, for gas outlet i have used escape, for wall i
have used reflect. is is write? (i am not sure for Dust outlet and gas
2. how to calculate efficiency?
i have set the injection from inlet in DPM, but i kept it off at the
start of run, after sometime i switch that on.
i have all details of particle size and numbers.
please give me the detail information regarding the same.
if you have some case please share with me.
Thank you for anticipation.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How can I find collection efficiency of cyclone by fluent?||YuTsuYu||FLUENT||1||July 2, 2013 15:46|
|DPM in CYCLONE SEPERATOR||nagi||FLUENT||6||March 6, 2011 20:59|
|Droplet Collision Efficiency Calculation using DPM||Virk||FLUENT||0||January 22, 2010 10:37|
|problem about DPM of cyclone separator simulation||jason||FLUENT||4||November 12, 2007 04:15|
|DPM of cyclone||fpingqian||FLUENT||3||September 27, 2004 04:35|