|
[Sponsors] |
March 16, 2012, 03:49 |
obtaining pressure in postprocessing
|
#1 |
New Member
Join Date: Dec 2011
Location: Spain
Posts: 25
Rep Power: 14 |
Hi , I have a little question.
I'm simulating a single circular cylinder(2D problem), and I want to know the pressure in the wake vortex zone in a single point (downstream at 4 diameter in the x-direction). I want to know how the pressure variate in time and plotting if it is possible. Somebody could help me?. Thanks in advance! |
|
March 16, 2012, 04:26 |
|
#2 |
Senior Member
|
Hi,
Yep, it's possible. Follow these steps: 1) create your desired point (probe): surface->point 2) solve->monitor->surfaces select your point and the variable you want to plot/write. (you can toggle on writing or plotting or printing desire data here). Note that you can set vertex minimum or maximum or average in report type panel. Bests,
__________________
Amir |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
Using pressure outlet BC | Shreyansh | FLUENT | 0 | November 5, 2010 14:57 |
Setup/monitor points of pressure and force coefficients | siw | CFX | 3 | October 22, 2010 06:07 |
Operating condition in Fluent | MASOUD | FLUENT | 3 | September 16, 2010 17:50 |
Setting pressure and velocity in inlet | Asghari | FLUENT | 5 | September 22, 2006 13:23 |