|March 19, 2012, 20:31||
Secondary phase move back
Join Date: May 2009
Posts: 15Rep Power: 9
I have simulated two-phase flow using Eulerian Model.
Primary phase is air and secondary phase is frost which seems almost solid.
So, I set up that viscosity of frost is much large value, 1.5e+06.
There is no problem except moving secondary phase.
Secondary phase is produced at edge front and then move back and back as time goes.
If I set up more large viscosity, it does not converge.
Is there a solution?
Have a nice day
|Thread||Thread Starter||Forum||Replies||Last Post|
|alphaEqn.H in twoPhaseEulerFoam||cheng1988sjtu||OpenFOAM Bugs||14||September 18, 2011 13:46|
|Simulating a Paper Filter in Multiphase: How to Make Impassable by Secondary Phase?||VT_Bromley||FLUENT||0||February 24, 2011 00:27|
|How much the value of secondary phase at the inlet||KBS||FLUENT||2||May 31, 2006 10:18|
|compressible two phase flow in CFX4.4||youngan||CFX||0||July 1, 2003 23:32|
|secondary phase velocity with ASMM ????||fawzy||FLUENT||4||November 19, 2001 12:40|