|March 23, 2012, 04:15||
Problems in a two-phase VOF modeling
Join Date: Nov 2010
Posts: 12Rep Power: 7
I'm trying to set up a two-phase flow simulation in a square channel. The computational domain (also BCs) shows in the following fig..
I wounder if there is any feasible way to mesh the whole domain using hexahedron grid. then, specify the green part as one fluid, and the rest part as the other. the two part are much like virtual volumes, so i do not need to mesh them separately. By doing this, the grids quality will be the best.
can any one give me some help/advise? thanks.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discrete Phase Modeling (Pipe erosion) in OF 2.1.0||mecbe2002||OpenFOAM||3||February 2, 2012 02:17|
|modeling two-phase flow with VOF solver||pranab_jha||FLUENT||5||March 12, 2010 00:20|
|Problems with multiphase modeling||magnounibo||FLUENT||0||April 30, 2009 03:59|
|species transport and discrete phase modeling ....||farhath||FLUENT||2||February 11, 2006 02:09|
|Differences between VOF and phase field||2L||Main CFD Forum||2||July 4, 2004 13:30|