|
[Sponsors] |
March 27, 2012, 20:54 |
vacuum modelling
|
#1 |
New Member
syed basha
Join Date: Sep 2011
Location: india
Posts: 1
Rep Power: 0 |
hello,
i am in a learner stage for fluent, i have to solve a problem,its a assembly with two tubes, inner and outer tube have a gap of about 5mm,this region has to be maintained at vacuum and flow takes place at inner tube and heat flux has to be given at outer surface of outer tube,can anyoine guide me........ |
|
Tags |
vaacuum modelling |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
radiation modeling in vacuum | mirko | OpenFOAM Programming & Development | 7 | May 20, 2016 08:31 |
Assistance in Vacuum pump simulation | enr_venkat | CFX | 5 | November 20, 2012 11:50 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
Unsteady modelling technique? | Carlos | FLUENT | 0 | September 26, 2008 11:37 |