Home > Forums > Software User Forums > ANSYS > FLUENT

how to define zone as plane in fluent simulation?

Mark Forums Read

Reply

Search this Thread

April 6, 2012, 09:45	how to define zone as plane in fluent simulation?	#1
TURBO_SPP New Member panpan song Join Date: Apr 2012 Posts: 5 Rep Power: 14	hi, dear everyone today, i have set up a 3d simulation. however, when previewing the dynamic mesh, i got a problem. Warning: Geometry of zone ...isn't defined as plane. Assuming plane for extrusion....how to solve it?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using a Plane id in Fluent UDF	cdf_user	Fluent UDF and Scheme Programming	13	October 17, 2023 00:06
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52
Fluent incident radiation problem	Michael Schwarz	Main CFD Forum	0	October 21, 1999 05:56

All times are GMT -4. The time now is 01:30.