|December 4, 2012, 15:52||
Would you do this training course?
Join Date: Dec 2012
Posts: 4Rep Power: 5
Do you think that they are charging a reasonable price for their course?
The course is titled "Introductory Training on ANSYS DesignModeler, ANSYS Meshing and ANSYS Fluent". It's a 5 day course and they charge Rs 7000 + taxes for each day!!! Rs(INR) 7000 is equal to USD 128. But how much an Indian would feels is, USD 128*2.5 = $320 (after adjusting Purchasing Power Parity of the Indian Rupees).
You can see what the course has to offer on the page in the link. Do you think it's a total worth for money program? What would be your decision if you were planning to do a training course on CFD?
Thanks a lot!
Last edited by ThePie; December 4, 2012 at 16:16.
|December 4, 2012, 16:59||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
download the training material, join the ANSYS MESHING AND GEOMETRY section, and start practicing and helping people... i'm sure you will learn a lot...
New to ICEM CFD, try this document --> http://goo.gl/G2gkE
|Thread||Thread Starter||Forum||Replies||Last Post|
|OpenFOAM Training in Munich, Nov. 13-15, 2012||CFD+engineering||OpenFOAM Announcements from Other Sources||0||September 27, 2012 08:14|
|OpenFOAM Training Course in Germany||thg||OpenFOAM Announcements from Other Sources||0||February 28, 2011 06:03|
|OpenFOAM Training Jan-Jun 2011||opencfd||OpenFOAM Announcements from ESI-OpenCFD||1||September 7, 2010 07:51|
|Coupled 1D/3D STAR-CD Training||CD adapco Group Marketing||CD-adapco||1||November 13, 2002 16:48|
|STAR-CD advanced training in Sweden||CD adapco Group Marketing||CD-adapco||0||January 2, 2002 07:29|