|
[Sponsors] |
May 7, 2012, 11:24 |
Ciem (ansys)
|
#1 |
New Member
Join Date: May 2012
Posts: 11
Rep Power: 13 |
I am new to this forum,
I´m doing the final project of my career. I´m using the program ICEM (ANSYS) to do the meshing of all the components of a valve. After, I´ll have to do a simulation with FLUENT to decide what is the best material, angle... My question is: When I finish all the meshes , is it possible to put all meshes in the same project and indicate the material represents each mesh? How can i do it? Is there any better option? Thank you very much |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Command Line Run for ANSYS | Liaquat | ANSYS | 11 | April 19, 2018 09:49 |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
Fluid structure interaction | jnattia | Main CFD Forum | 25 | May 21, 2015 09:16 |
Ansys workbench problem | Jonny6001 | ANSYS | 2 | September 30, 2010 12:59 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |