|
[Sponsors] |
July 14, 2012, 20:47 |
how to mesh multiparts as one body
|
#1 |
Member
yahya
Join Date: Jul 2012
Posts: 43
Rep Power: 13 |
I trying to mesh the flow inside a separator
I have a cylinder full of a fluid with two surface plates as internals When i meshed it i found that each part was meshed alone so i want to know to connect the meshing as one part in order to notice the influence of the plate on the flow behavior the attachment shows the separator that I'm meshing |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 06:25 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |