|August 10, 2012, 01:47||
Join Date: Aug 2012
Posts: 1Rep Power: 0
i am new to ansys cfx and just trying to get my head around it and could use some help :-D?
i would like to use an actuator disk in order to model my turbine.
My first problem is so that i do not know how to tell cfx to not treat my disk as a wall but rather to ignore the disk. Later i will include expressions to simulate the forces from the blades.
I used a Boolean operator to subdract my disk from my enclosure. i hope this information is sufficient.
Thanks for your help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|HA Tidal Turbine Simulation||Andy QUB||FLUENT||5||September 19, 2015 06:38|
|FSI - Wind Turbine||AUN||CFX||13||August 29, 2012 16:44|
|Boundary condition setting regarding turbine simulation using CFX||Lacerlacer||CFX||11||March 12, 2012 10:32|
|Problem with torque output from a turbine simulation.||pa-dundas||FLUENT||3||August 30, 2011 12:25|
|I read, did, searched and still not get the result, pls help me out my tidal turbine||altomos||CFX||7||March 31, 2011 10:08|