|December 17, 2012, 05:51||
Velocity inlet within a domain
Join Date: May 2012
Posts: 4Rep Power: 6
I am modelling a different temperature upstream and downstream of a simplified choke geometry.
I have modelled a velocity inlet upstream of the choke and a pressure outlet downstream of the choke.
I had then hoped to model the temperature drop across the choke by setting a face (at the choke position) as a pressure outlet on the upstream side and then a velocity inlet on the downstream side of the same face.
I had hoped the shadow wall function in Fluent would have allowed different sides of the same face to be set as a velocity inlet and pressure outlet but the option is not available.
I am modelling my mesh with Design Modeler.
Does anyone know what I should set the wall as in Design Modeler to allow me to model the above?
Thanks in advance for any help
|choke, shadow wall, velocity inlet face|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Difficulty in calculating angular velocity of Savonius turbine simulation||alfaruk||CFX||8||December 3, 2013 17:51|
|Setting Density for Velocity Inlet Face||arkie87||FLUENT||0||November 7, 2012 16:15|
|patching velocity profile to the inlet face of domain||vasuaero1988||Fluent UDF and Scheme Programming||1||September 29, 2010 03:49|
|Velocity BC in cyclic 2D domain||Ivo||OpenFOAM||1||July 30, 2010 11:22|
|time varying inlet velocity||Zhe Liu||CFX||0||July 31, 2008 06:56|