2-way FSI, System Coupling error

Arty · March 4, 2013, 07:32

Hello, everybody!
I am trying to perform a 2-way FSI considering a gas compressor blade. So, I linked Transient structural with Fluid flow (Fluent), and connected the setup cells of those with System Coupling.
When I update the Solution cell of the System Coupling I get the following message:
System coupling run completed with errors: the MAPDL beginning time 1 is different from the System Coupling service beginning time 0.

Does anyone can tell what should I do to settle it?

levivad · Yesterday, 14:41

you need to reset the solution cell in the structural analysis (go to the solution--> RMB -->reset data)

March 4, 2013, 07:32	2-way FSI, System Coupling error	#1
Arty New Member Join Date: Mar 2013 Posts: 5 Rep Power: 2	Hello, everybody! I am trying to perform a 2-way FSI considering a gas compressor blade. So, I linked Transient structural with Fluid flow (Fluent), and connected the setup cells of those with System Coupling. When I update the Solution cell of the System Coupling I get the following message: System coupling run completed with errors: the MAPDL beginning time 1 is different from the System Coupling service beginning time 0. Does anyone can tell what should I do to settle it?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Undeclared Identifier Errof UDF	SteveGoat	Fluent UDF and Scheme Programming	4	May 18, 2012 03:27
Problem running perturbUCyl	sen.1986	OpenFOAM	14	March 23, 2012 05:12
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
Compile calcMassFlowC	aurore	OpenFOAM	11	July 11, 2008 07:48
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 15:16

Yesterday, 14:41		#2
levivad New Member Join Date: May 2013 Posts: 2 Rep Power: 0	you need to reset the solution cell in the structural analysis (go to the solution--> RMB -->reset data)